Institutes
Refine
Document Type
- Article (3)
- Doctoral Thesis (1)
- Master's Thesis (1)
Language
- English (5)
Has Fulltext
- yes (5)
Is part of the Bibliography
- no (5)
Keywords
- ALICE (5) (remove)
Institute
- Physik (5)
The production of low-mass dielectrons is one of the most promising tools for the investigation of chiral symmetry restoration and thermal radiation from the QGP created in heavy-ion collisions. To single out the signal characteristics of the QGP, it is crucial to understand the primordial e+e− pair production in vacuum, i.e. in inelastic proton-proton (pp) collisions. Low-mass dielectrons have been measured with ALICE at the LHC in pp collisions at s=7and13TeV, and in Pb–Pb collisions at sNN=2.76TeV. An overview of the results on dielectron production is presented, together with their implications for the direct-photon and heavy-quark production.
The production of light neutral mesons in AA collisions probes the physics of the Quark-Gluon Plasma (QGP), which is formed in heavy-ion collisions at the LHC. More specifically, the centrality dependent neutral meson spectra in AA collisions compared to its spectra in minimum-bias pp collisions, scaled with the number of hard collisions, provides information on the energy loss of partons traversing the QGP. The measurement allows to test with high precision the predictions of theoretical model calculations. In addition, the decay of the π0 and η mesons are the dominant back- grounds for all direct photon measurements. Therefore, pushing the limits of the precision of neutral meson production is key to learning about the temperature and space-time evolution of the QGP.
In the ALICE experiment neutral mesons can be detected via their decay into two photons. The latter can be reconstructed using the two calorimeters EMCal and PHOS or via conversions in the detector material. The excellent momentum resolution of the conversion photons down to very low pT and the high reconstruction efficiency and triggering capability of calorimeters at high pT, allow us to measure the pT dependent invariant yield of light neutral mesons over a wide kinematic range.
Combining state-of-the-art reconstruction techniques with the high statistics delivered by the LHC in Run 2 gives us the opportunity to enhance the precision of our measurements. In these proceedings, new ALICE run 2 preliminary results for neutral meson production in pp and Pb–Pb collisions at LHC energies are presented.
Quarkonia, i.e. bound states of bb‾ and cc‾ quarks, are powerful observables to study the properties of nuclear matter under extreme conditions. The formation of a Quark-Gluon Plasma (QGP), which is predicted by lattice QCD calculations at high temperatures as reached at the LHC energies, has a strong influence on the production and behavior of quarkonia. The latest ALICE results on bottomonium and charmonium production in nucleus−nucleus collisions are presented. This includes measurements of the ϒ(1S) and ϒ(2S) nuclear modification factor (RAA) at forward rapidity and the J/ψ RAA and ν2 as a function of centrality, pT and rapidity in Pb–Pb collisions at sNN=5.02TeV. Also, first results from J/ψ measurements in Xe–Xe collisions at sNN=5.44TeV are presented. Further on, the experimental results are compared to various calculations from theoretical models.
During RUN3 (2021-2023) of the Large Hadron Collider, the Time Projection Chamber (TPC) of ALICE will be operated with quadruple stacks of Gas Electron Multipliers (GEMs). This technology will allow to overcome the rate limitation due to the gated operation of the Multi-Wire Proportional Chambers (MWPCs) used in RUN1 (2009-2013) and RUN2 (2015-2018).
As part of the Upgrade project, long-term irradiation tests, so called "ageing tests", have been carried out. A test setup with a detector using a quadruple stack of 10x10cm2 GEMs was built and operated in Ar-CO2 and Ne-CO2-N2 gas mixtures. The detector performance such as gas gain and energy resolution were monitored continuously. In addition, outgassing tests of materials used for the assembly process of the upgraded TPC were performed. To reach the expected dose of the GEM-based TPC, the detector was operated at much higher gains than the TPC. It was found, that the GEMs could keep their performance within the projected lifetime of the TPC. Most of the tested materials showed no negative impact on the detector. For the tested epoxy adhesive no certain conclusion could be drawn.
At much higher doses than expected for the upgraded TPC, a new phenomenon was observed, which changed the hole geometry of the GEMs and led to a degradation of the energy resolution. Even though its occurrence is not expected during the lifetime of the GEM-based TPC, simulations were carried out to study this effect more systematically. The simulations confirmed, that a change of the hole geometries of the GEMs, lead to an increase of the local gain variation, which results in a decrease of the energy resolution.
Furthermore the effect of methane as quench gas on GEMs was studied, even though this gas is not foreseen to be used in the TPC. From ageing tests with single-wire proportional counters it is well known that hydrocarbons are produced in the plasma of the avalanches, which cover the electrodes and lead to a degradation of the detector performance. Even though GEMs have a quite different geometry, the ageing tests showed, that also this technology tends to methane-induced ageing. A loss of gas gain as well as a degradation of the energy resolution due to deposits on the electrodes was monitored. A qualitative and quantitative comparison between ageing in GEMs and proportional counters was performed.
A new era in experimental nuclear physics has begun with the start-up of the Large Hadron Collider at CERN and its dedicated heavy-ion detector system ALICE. Measuring the highest energy density ever produced in nucleus-nucleus collisions, the detector has been designed to study the properties of the created hot and dense medium, assumed to be a Quark-Gluon Plasma.
Comprised of 18 high granularity sub-detectors, ALICE delivers data from a few million electronic channels of proton-proton and heavy-ion collisions.
The produced data volume can reach up to 26 GByte/s for central Pb–Pb
collisions at design luminosity of L = 1027 cm−2 s−1 , challenging not only the data storage, but also the physics analysis. A High-Level Trigger (HLT) has been built and commissioned to reduce that amount of data to a storable value prior to archiving with the means of data filtering and compression without the loss of physics information. Implemented as a large high performance compute cluster, the HLT is able to perform a full reconstruction of all events at the time of data-taking, which allows to trigger, based on the information of a complete event. Rare physics probes, with high transverse momentum, can be identified and selected to enhance the overall physics reach of the experiment.
The commissioning of the HLT is at the center of this thesis. Being deeply embedded in the ALICE data path and, therefore, interfacing all other ALICE subsystems, this commissioning imposed not only a major challenge, but also a massive coordination effort, which was completed with the first proton-proton collisions reconstructed by the HLT. Furthermore, this thesis is completed with the study and implementation of on-line high transverse momentum triggers.