Refine
Year of publication
- 2019 (274) (remove)
Document Type
- Article (128)
- Preprint (110)
- Doctoral Thesis (18)
- Conference Proceeding (17)
- Habilitation (1)
Language
- English (274) (remove)
Has Fulltext
- yes (274)
Is part of the Bibliography
- no (274) (remove)
Keywords
- Hadron-Hadron scattering (experiments) (4)
- Heavy Ion Experiments (4)
- Heavy-ion collisions (4)
- ALICE (3)
- LHC (2)
- Lattice QCD (2)
- NA61/SHINE (2)
- Phase Diagram of QCD (2)
- QCD equation of state (2)
- QCD phase diagram (2)
Institute
- Physik (274) (remove)
The procedure for the energy calibration of the high granularity electromagnetic calorimeter PHOS of the ALICE experiment is presented. The methods used to perform the relative gain calibration, to evaluate the geometrical alignment and the corresponding correction of the absolute energy scale, to obtain the nonlinearity correction coefficients and finally, to calculate the time-dependent calibration corrections, are discussed and illustrated by the PHOS performance in proton-proton (pp) collisions at √s=13 TeV. After applying all corrections, the achieved mass resolutions for π0 and η mesons for pT > 1.7 GeV/c are σmπ0 = 4.56 ± 0.03 MeV/c2 and σmη = 15.3 ± 1.0 MeV/c2, respectively.
At the Large Hadron Collider at CERN in Geneva, Switzerland, atomic nuclei are collided at ultra-relativistic energies. Many final-state particles are produced in each collision and their properties are measured by the ALICE detector. The detector signals induced by the produced particles are digitized leading to data rates that are in excess of 48 GB/s. The ALICE High Level Trigger (HLT) system pioneered the use of FPGA- and GPU-based algorithms to reconstruct charged-particle trajectories and reduce the data size in real time. The results of the reconstruction of the collision events, available online, are used for high level data quality and detector-performance monitoring and real-time time-dependent detector calibration. The online data compression techniques developed and used in the ALICE HLT have more than quadrupled the amount of data that can be stored for offline event processing.
Measurements of the π±, K±, and proton double differential yields emitted from the surface of the 90-cm-long carbon target (T2K replica) were performed for the incoming 31 GeV/c protons with the NA61/SHINE spectrometer at the CERN SPS using data collected during 2010 run. The double differential π± yields were measured with increased precision compared to the previously published NA61/SHINE results, while the K± and proton yields were obtained for the first time. A strategy for dealing with the dependence of the results on the incoming proton beam profile is proposed. The purpose of these measurements is to reduce significantly the (anti)neutrino flux uncertainty in the T2K long-baseline neutrino experiment by constraining the production of (anti)neutrino ancestors coming from the T2K target.
Measurement of ϒ(1S) elliptic flow at forward rapidity in Pb-Pb collisions at √sNN = 5.02 TeV
(2019)
The first measurement of the ϒ(1S) elliptic flow coefficient (v2) is performed at forward rapidity (2.5 < y < 4) in Pb–Pb collisions at √sNN = 5.02 TeV with the ALICE detector at the LHC. The results are obtained with the scalar product method and are reported as a function of transverse momentum (pT) up to 15 GeV/c in the 5%–60% centrality interval. The measured Υ(1S)v2 is consistent with 0 and with the small positive values predicted by transport models within uncertainties. The v2 coefficient in 2 < pT < 15 GeV/c is lower than that of inclusive J/ψ mesons in the same pT interval by 2.6 standard deviations. These results, combined with earlier suppression measurements, are in agreement with a scenario in which the Υ(1S) production in Pb–Pb collisions at LHC energies is dominated by dissociation limited to the early stage of the collision, whereas in the J/ψ case there is substantial experimental evidence of an additional regeneration component.