Refine
Year of publication
- 2009 (3) (remove)
Document Type
- Doctoral Thesis (3)
Has Fulltext
- yes (3)
Is part of the Bibliography
- no (3)
Keywords
- Adenin (1)
- Azobenzol (1)
- Azobenzolderivate (1)
- Cation coupled symporters (1)
- Cyclopenten (1)
- DFWM (1)
- ESIPT (1)
- Femtosekundenspektroskopie (1)
- Festkörperunterstützte Membranen (1)
- Gasphase (1)
Institute
A solid-supported membrane (SSM) is an alkanethiol/lipid hybrid membrane with comparable lipid mobility, conductivity, and capacitance than a black lipid membrane (BLM). However, mechanical perturbations, which usually destroy a BLM, do not influence the life-time of a SSM, which is mechanically so stable that solutions may be rapidly exchanged at its surface. This key property has been utilized in this thesis to characterize electrophysiologically two bacterial secondary active transporters (MelB and LacY) as well as to investigate the specific interactions between ions and lipid membranes. These three different projects are summarized below: (1) The properties of lipid membranes, which represent the most important biological interface between intracellular and extracellular compartments, are essentially modulated by the ionic composition of the surrounding aqueous medium. To investigate specific interactions between ions and lipid membranes, solutions of different ionic composition were exchanged at the surface of a SSM through a flow system. This solution exchange resulted in charge translocations that were interpreted in terms of binding of the ions to the lipid headgroups at the SSM surface. We found that chaotropic anions and kosmotropic cations are attracted to the membrane independent of the membrane composition. In particular, the same behaviour was found for lipid headgroups bearing no charge like monoolein. This general trend is modulated by the electrostatic interaction of the ions with the lipid headgroup charge. Our experimental results are in agreement with recent molecular dynamic simulations of PC membranes. (2) Rapid solution exchange on a solid-supported membrane (SSM) is investigated using fluidic structures and a solid-supported membrane in a wall jet geometry. The flow was analyzed with a new technique based on specific ion interactions with the surface combined with an electrical measurement. The critical parameters affecting the time course of the solution exchange and the transfer function describing the time resolution of the SSM system were determined. The experimental data indicate that the solution transport follows a plug flow geometry while the rise of the surface concentration can be approximated by Hagen Poiseuille flow with ideal mixing at the surface of the SSM. Using an improved cuvette design a solution exchange as fast as 2 ms was achieved at the surface of a solid supported membrane. As an application of the technique the rate constant of a fast electrogenic reaction in the melibiose permease MelB, a bacterial (Escherichia coli) sugar transporter, is determined. For comparison, the kinetics of a conformational transition of the same transporter was measured using stopped-flow tryptophan fluorescence spectroscopy. The relaxation time constant obtained for the charge displacement agrees with that determined in the stopped-flow experiments. This supports the previous proposition that upon sugar binding MelB undergoes an electrogenic conformational transition with a rate constant of k ~ 250 s-1. (3) Electrogenic events due to activity of wild-type lactose permease from Escherichia coli (LacY) were investigated with proteoliposomes containing purified LacY adsorbed on a solid-supported membrane electrode. Downhill sugar/H+ symport into the proteoliposomes generates transient currents. Studies at different lipid to protein ratios and at different pH values, as well as inactivation by N-ethylmaleimide, show that the currents are due specifically to the activity of LacY. From analysis of the currents under different conditions and comparison with biochemical data, it is apparent that the predominant electrogenic event in downhill sugar/H+ symport is H+ release. In contrast, LacY mutants E325A and C154G, which bind ligand normally but are severely defective with respect to lactose/H+ symport, exhibit a minor electrogenic event upon addition of LacY-specific substrates, representing only 6% of the total charge displacement of the wild-type. This activity is due either to substrate binding per se or to a conformational transition following substrate binding. We propose that turnover of LacY involves at least two electrogenic reactions: (i) a minor reaction that occurs upon sugar binding and is due to a conformational transition in LacY; and (ii) a major reaction due to cytoplasmic release of H+ during downhill sugar/H+ symport, which is the limiting step for this mode of transport.
Die Fluoreszenz der organischen Verbindung ''Pigment Yellow 101'' wurde mittels zeitaufgelöster Anreg-Abtast-Spektroskopie im sichtbaren Spektralbereich untersucht. P.Y. 101 und ein Derivat mit zusätzlichen Methylgruppen an den Azin-Kohlenstoffatomen, wurden mit zwei Derivaten verglichen, die keine Hydroxygruppen tragen und nicht fluoreszieren. Es konnte gezeigt werden, dass die Fluoreszenz bei diesen Verbindungen eine intrinsische Eigenschaft ist, die von der Reihenfolge der angeregten Zustände bestimmt wird. Bei Derivaten mit Hydroxygruppe entspricht der niedrigste angeregte Zustand einem pp*-Übergang, welcher hauptsächlich durch Fluoreszenz zurück in den Grundzustand gelangt. Bei den Verbindungen ohne Hydroxygruppe fehlt die stabilisierende Wasserstoffbrücke, die zur Absenkung des entsprechenden Zustands führt, so dass bei diesen Derivaten der unterste angeregte Zustand einem np*-Übergang entspricht, der optisch verboten ist und somit nicht direkt populiert wird. Bei der Anregung wird ein höher angeregter Zustand bevölkert, der in den niedrigsten angeregten Zustand relaxiert, welcher über eine konische Durchschneidung schnell und strahlungsfrei erreicht werden kann. Der niedrigste angeregte Zustand schneidet seinerseits den Grundzustand, so dass auch die Repopulierung des Ausgangszustands schnell, effizient und strahlungslos abläuft. Eine ganz andere Art der Photochemie wird bei Azobenzol (AB) und AB-Derivaten beobachtet. Durch Isomerisierung um die N-N-Doppelbindung wird ein Photoprodukt gebildet, das cis-Isomer. Die Quantenausbeute der Isomerisierung ist dabei abhängig davon, welcher elektronische Übergang angeregt wurde. Substituenten am AB üben unterschiedlichen Einfluss auf die elektronischen Eigenschaften aus: Elektronegative Gruppen in meta-Position zur Diazobrücke verändern die Lage der Absorptionsbanden kaum, ebensowenig die Rate der thermischen Rückisomerisierung und auch die Dynamik nach Photoanregung zeigt keine signifikanten Unterschiede in Abhängigkeit vom Substituenten und kann in Analogie an unsubstituiertes AB interpretiert werden. Nach Anregung des np*-Übergangs zerfällt der angeregte Zustand biexponentiell. Die Anregung des pp*-Übergangs, dem optisch erlaubten Übergang, führt zur Population des zweiten angeregten Zustands. Entlang einer konischen Durchschneidung wird schnell und effizient der erste angeregte Zustand populiert. Dieser Prozess zeigt sich bei den zeitaufgelösten Messungen in einer schnellen Zerfallszeit, die nur wenige hundert Femtosekunden beträgt. Die nun folgenden Prozesse finden im ersten angeregten Zustand statt und sind vergleichbar mit den Prozessen nach np*-Anregung. Der Hauptunterschied zwischen den beiden Dynamiken im S1-Zustand ist die Ausgangsgeometrie, mit der die Moleküle diesen Zustand populieren (Franck-Condon-Bereich bei direkter Anregung, bzw. eine große Bandbreite an Geometrien nach dem S2-S1-Übergang), sowie die Schwingungsenergie die das System jeweils besitzt. Auch nach ursprünglicher S2-Anregung können zwei Zerfallszeiten dem ersten angeregten Zustand zugeordnet werden, die analog der direkten Population als Geometrieänderung in Richtung des Potentialminimums und Isomerisierung bzw. Rückkehr in den Grundzustand interpretiert werden und in der Größenordnung von einer bzw. fünf Pikosekunden liegen. Die Modifizierung von Peptiden mit Azobenzol stellt einen Weg dar, zeitlich synchronisiert, eine Störung in der Struktur zu induzieren. Dieses Konzept wurde bereits erfolgreich zur Untersuchung der Faltung zyklischer Peptide eingesetzt. Modifizierte Kollagenstränge sind eine Erweiterung dieses Prinzips, da sie eine Möglichkeit darstellen, die Tertiärstruktur eines Peptids zu adressieren. Für das vorliegende Azokollagen konnte gezeigt werden, dass die gewählte Aminosäuresequenz auch nach Anbringen der Azobenzolklammer zu gefaltetem Kollagen führt, welches thermodynamisch stabil ist. Der Schmelzpunkt der Tripelhelix liegt unter den gewählten Bedingungen bei 55°C. Die Isomerisierung des Azobenzols induziert eine Störung der Tertiärstruktur, die zur teilweisen Entfaltung der Tripelhelix führt, was ein reversibler Prozess ist. Eine vollständige Entfaltung findet erst bei Temperaturen oberhalb des Schmelzpunkts statt. Zeitaufgelöste Messungen im sichtbaren Spektralbereich zeigten, dass die Schalterdynamik durch Anbringung an das Peptid nicht signifikant im Vergleich zum reinen AB-Schalter verändert wird.
Large amplitude intramolecular motions in non-rigid molecules are a fundamental issue in chemistry and biology. The conventional approaches for study these motions by far-infrared and microwave spectroscopy are not applicable when the molecule is non-polar. Therefore, in the current thesis an alternative approach for the investigation of large amplitude intramolecular motions was developed and tested. This new method is based on femtosecond rotational degenerate four-wave mixing spectroscopy (fs DFWM), which is a particular implementation of rotational coherence spectroscopy. The method was successfully applied for the investigation of pseudorotation in pyrrolidine and the ring-puckering vibration in cyclopentene. Another important subject is the photophysics of molecules and molecular clusters which have an ultrashort lifetime of their electronically excited state (photoreactivity). These ultrashort lifetimes often represent a protective mechanism causing photostability. The photoreactivity is usually the manifestation either of an “elementary” reaction, such as proton or electron transfer, which occurs in the excited state or of a fast non-radiative deactivation processes, such as internal conversion via conical intersection of the electronically excited and ground state. Due to a short-lived excited state, the conventional vibrational spectroscopic methods, such as IR depletion detected by resonance two-photon ionization spectroscopy (IR/R2PI), are not applicable for the structural investigation of these systems. Therefore, new approach, termed IR depletion detected by multiphoton ionization with femtosecond laser pulses (IR/fsMPI), was developed for studying the structure of photoreactive microsolvated molecules. The IR/fsMPI technique was applied for investigating the clusters of 1H-pyrrolo[3,2-h]quinoline with water/methanol as well as adenine- and 9-methyl-adenine-hydrates. In addition, the excited state dynamics of bifunctional azaaromatic molecule 7-(2'-pyridyl)indole (7PyIn) was studied by femtosecond pump-probe resonance excitation multiphoton ionization technique (fs REMPI). Under electronic excitation of this molecule a fast proton transfer (phototautomerization) takes place, which is followed by radiationless excited state deactivation process. The fs REMPI spectra lead to the conclusion that the phototautomerization in 7PyIn is coupled with a twisting of the molecule, and that the twisting provides an efficient channel for ultrafast radiationless excited state deactivation. This pattern of excited-state tautomerization/deactivation might be quite general.