Universitätspublikationen
Refine
Year of publication
- 2004 (4) (remove)
Document Type
- Article (2)
- Conference Proceeding (1)
- Doctoral Thesis (1)
Has Fulltext
- yes (4)
Is part of the Bibliography
- no (4)
Institute
- Geowissenschaften (4) (remove)
Balloon-borne measurements of CFC-11 (on flights of the DIRAC in situ gas chromatograph and the DESCARTES grab sampler), ClO and O3 were made during the 1999/2000 winter as part of the SOLVE-THESEO 2000 campaign. Here we present the CFC-11 data from nine flights and compare them first with data from other instruments which flew during the campaign and then with the vertical distributions calculated by the SLIMCAT 3-D CTM. We calculate ozone loss inside the Arctic vortex between late January and early March using the relation between CFC-11 and O3 measured on the flights, the peak ozone loss (1200 ppbv) occurs in the 440–470 K region in early March in reasonable agreement with other published empirical estimates. There is also a good agreement between ozone losses derived from three independent balloon tracer data sets used here. The magnitude and vertical distribution of the loss derived from the measurements is in good agreement with the loss calculated from SLIMCAT over Kiruna for the same days.
Partial melting of crustal and mantle rocks under pressure from impedance spectroscopy measurements
(2004)
The purpose of this work is to achieve a better understanding of the physical properties of rocks during partial melting processes. The electrical conductivity of some crustal and upper mantle rocks was measured prior and above the melting under pressure. The variations of the electrical conductivity were compared with the distribution of melt in partially molten rock samples. The electrical conductivity was estimated from the impedance spectroscopy at temperatures between 800 and 1450˚C and at pressures between 0.3 and 2 GPa. These measurements were performed in a piston cylinder apparatus. At temperatures above the melting, samples were equilibrated during a long time and subsequently quenched. Thin sections were prepared and topology, volume fraction and chemical composition of melt was analyzed by using a microprobe. Above the solidus temperature, the electrical conductivity increases for about 1 to 2 orders of magnitude in comparison with non-melted rocks. The "melt effect" seems to reflect the formation of an interconnected network of melt. When a complete melt connectivity is established, the charge transport follows the network of the formed melt films at grain boundaries. Usually, it takes a long time in order to reach a steady state of the electrical resistance in partially molten rocks. Only when a steady state of the electrical resistance is achieved, the bulk conductivity of a sample can be measured properly. The time-independent electrical conductivity were found only after 200 h of annealing time at a desired temperature.
Usually, the measurements of a dihedral angle on grain-liquid interfaces in rocks show that the wetting of grain faces start to develop at temperatures slightly above the solidus temperature. The development of these faces should lead to a continuous melt network even at small melt fractions of few wt.%. This result is not confirmed by our electrical conductivity measurements. The complete interconnection of the melt phase, which was mark by an increase of the electrical conductivity, corresponds to a temperature significantly above the solidus temperature, for at least 30-50˚C. The development of these faces stimulate a significant increase of the electrical conductivity, and corresponds to the occurence of at least 5 wt.% of a melt fraction. This result could be explained by deviations from the textural equilibrium of a melt phase topology in partially molten samples due to heterogeneous grain size distribution, misorientation of grains and anisotropy of the superficial energy of adjacent grain boundaries.
Some mixing models that allow to calculate the electrical conductivity of a composite as a function of a melt fraction were examined and the results of these calculations are discussed.
The experimental results were compared to the conductivity data obtained from magnetotelluric and electromagnetic measurements in the Northern part of mid-Atlantic ridge where a series of magma chambers are presumably located. There is a good agreement between our conductivity values for a melt fraction of 10-13 the conductivity estimated in the Reykjanes ridge zone.
We have used the SLIMCAT 3-D off-line chemical transport model (CTM) to quantify the Arctic chemical ozone loss in the year 2002/2003 and compare it with similar calculations for the winters 1999/2000 and 2003/2004. Recent changes to the CTM have improved the model's ability to reproduce polar chemical and dynamical processes. The updated CTM uses σ-θ as a vertical coordinate which allows it to extend down to the surface. The CTM has a detailed stratospheric chemistry scheme and now includes a simple NAT-based denitrification scheme in the stratosphere.
In the model runs presented here the model was forced by ECMWF ERA40 and operational analyses. The model used 24 levels extending from the surface to ~55 km and a horizontal resolution of either 7.5°×7.5° or 2.8°×2.8°. Two different radiation schemes, MIDRAD and the CCM scheme, were used to diagnose the vertical motion in the stratosphere. Based on tracer observations from balloons and aircraft, the more sophisticated CCM scheme gives a better representation of the vertical transport in this model which includes the troposphere. The higher resolution model generally produces larger chemical O3 depletion, which agrees better with observations.
The CTM results show that very early chemical ozone loss occurred in December 2002 due to extremely low temperatures and early chlorine activation in the lower stratosphere. Thus, chemical loss in this winter started earlier than in the other two winters studied here. In 2002/2003 the local polar ozone loss in the lower stratosphere was ~40% before the stratospheric final warming. Larger ozone loss occurred in the cold year 1999/2000 which had a persistently cold and stable vortex during most of the winter. For this winter the current model, at a resolution of 2.8°×2.8°, can reproduce the observed loss of over 70% locally. In the warm and more disturbed winter 2003/2004 the chemical O3 loss was generally much smaller, except above 620 K where large losses occurred due to a period of very low minimum temperatures at these altitudes.