Refine
Document Type
- Doctoral Thesis (2) (remove)
Language
- English (2)
Has Fulltext
- yes (2)
Is part of the Bibliography
- no (2)
Keywords
- Permeasen (2) (remove)
Institute
- Biochemie und Chemie (2) (remove)
A solid-supported membrane (SSM) is an alkanethiol/lipid hybrid membrane with comparable lipid mobility, conductivity, and capacitance than a black lipid membrane (BLM). However, mechanical perturbations, which usually destroy a BLM, do not influence the life-time of a SSM, which is mechanically so stable that solutions may be rapidly exchanged at its surface. This key property has been utilized in this thesis to characterize electrophysiologically two bacterial secondary active transporters (MelB and LacY) as well as to investigate the specific interactions between ions and lipid membranes. These three different projects are summarized below: (1) The properties of lipid membranes, which represent the most important biological interface between intracellular and extracellular compartments, are essentially modulated by the ionic composition of the surrounding aqueous medium. To investigate specific interactions between ions and lipid membranes, solutions of different ionic composition were exchanged at the surface of a SSM through a flow system. This solution exchange resulted in charge translocations that were interpreted in terms of binding of the ions to the lipid headgroups at the SSM surface. We found that chaotropic anions and kosmotropic cations are attracted to the membrane independent of the membrane composition. In particular, the same behaviour was found for lipid headgroups bearing no charge like monoolein. This general trend is modulated by the electrostatic interaction of the ions with the lipid headgroup charge. Our experimental results are in agreement with recent molecular dynamic simulations of PC membranes. (2) Rapid solution exchange on a solid-supported membrane (SSM) is investigated using fluidic structures and a solid-supported membrane in a wall jet geometry. The flow was analyzed with a new technique based on specific ion interactions with the surface combined with an electrical measurement. The critical parameters affecting the time course of the solution exchange and the transfer function describing the time resolution of the SSM system were determined. The experimental data indicate that the solution transport follows a plug flow geometry while the rise of the surface concentration can be approximated by Hagen Poiseuille flow with ideal mixing at the surface of the SSM. Using an improved cuvette design a solution exchange as fast as 2 ms was achieved at the surface of a solid supported membrane. As an application of the technique the rate constant of a fast electrogenic reaction in the melibiose permease MelB, a bacterial (Escherichia coli) sugar transporter, is determined. For comparison, the kinetics of a conformational transition of the same transporter was measured using stopped-flow tryptophan fluorescence spectroscopy. The relaxation time constant obtained for the charge displacement agrees with that determined in the stopped-flow experiments. This supports the previous proposition that upon sugar binding MelB undergoes an electrogenic conformational transition with a rate constant of k ~ 250 s-1. (3) Electrogenic events due to activity of wild-type lactose permease from Escherichia coli (LacY) were investigated with proteoliposomes containing purified LacY adsorbed on a solid-supported membrane electrode. Downhill sugar/H+ symport into the proteoliposomes generates transient currents. Studies at different lipid to protein ratios and at different pH values, as well as inactivation by N-ethylmaleimide, show that the currents are due specifically to the activity of LacY. From analysis of the currents under different conditions and comparison with biochemical data, it is apparent that the predominant electrogenic event in downhill sugar/H+ symport is H+ release. In contrast, LacY mutants E325A and C154G, which bind ligand normally but are severely defective with respect to lactose/H+ symport, exhibit a minor electrogenic event upon addition of LacY-specific substrates, representing only 6% of the total charge displacement of the wild-type. This activity is due either to substrate binding per se or to a conformational transition following substrate binding. We propose that turnover of LacY involves at least two electrogenic reactions: (i) a minor reaction that occurs upon sugar binding and is due to a conformational transition in LacY; and (ii) a major reaction due to cytoplasmic release of H+ during downhill sugar/H+ symport, which is the limiting step for this mode of transport.
The melibiose permease (MelB) of E.coli functions as a secondary-active symporter by using the electrochemical H+, Na+, or Li+ gradient to accumulate, e.g., melibiose [review in Pourcher et al. 1990a]. The global and primary objective of this thesis was to apply pre-steady state methods for the investigation of reaction rates of individual steps in the cycle of MelB. Especially the melibiose binding induced transition was investigated by the solid-supported membrane (SSM) technique [Seifert et al. 1993] in combination with a rapid solution exchange system [Pintchovius and Fendler 1999] and with the Stopped-flow technique [Roughton 1934]. To approach this goal, either wild-type or mutated MelB were purified and reconstituted into liposomes as described [Pourcher et al. 1995]. Although the orientation of the proteins is a critical factor for the activity of MelB, it was, so far, unknown. To determine the orientation of the proteins in the liposomes, single Cys mutants R139C and R141C [Abdel-Dayem et al. 2003] were selectively labeled with 3-(N-maleimidylpropionyl)biocytin (MPB) and analyzed by SDS-PAGE and Western Blot. The assay indicated that most of the proteins are inside-out (ISO) oriented permitting to relate the pre-steady state electrical and fluorescence signals to the reverse transport activity of MelB. The melibiose induced electrical signal was investigated in wild-type MelB with the SSM technique. The transporter was activated by a substrate concentration jump, and transient currents were measured. When the transporter was preincubated with Na+ at saturating concentrations, a charge translocation in the protein upon melibiose binding could still be observed. This result demonstrates that binding of the uncharged substrate melibiose triggers a charge displacement in the protein. Further analysis showed that the charge displacement is neither related to extra Na+ binding to the transporter, nor to the displacement of already bound Na+ within MelB. Electrogenic melibiose binding is explained by a conformational change with concomitant displacement of charged amino acid side chains and/or a reorientation of helix dipoles. A kinetic model is suggested, in which Na+ and melibiose binding are distinct electrogenic processes associated with approximately the same charge displacement. Melibiose binding is fast in the presence of Na+ (k > 50 s-1). Furthermore, two previously identified transport deficient mutants of loop 4-5, R141C and E142C [Abdel-Dayem et al. 2002, Séry 2002], were purified and extensively studied with the SSM. Whereas the electrical signals from control cysteine-less mutant showed a bi-exponential time course of decay, those from R141C or E142C consisted of only a single fast exponential component, and the slow decaying component associated with substrate translocation was missing. The electrical signals evoked by a melibiose concentration jump in the presence of Na+ were much smaller than the corresponding signals in C-less MelB. Furthermore, R141C lost the stimulating effect of melibiose on Na+ binding. Steady-state Trp fluorescence spectroscopy revealed impaired conformational changes after melibiose binding in the mutants and fluorescence resonance energy transfer (FRET) measurements indicated that the mutants still show cooperative modification of their sugar binding sites by Na+. These data suggest that loop 4-5 contributes to the coordinated interactions between the ion- and sugar binding site and participates in conformational changes after melibiose binding that are essential for the subsequent obligatory coupled translocation of substrates. By using the Stopped-flow technique, three different approaches were followed. First, the intrinsic Trp fluorescence of MelB, known to increase upon melibiose binding [Mus-Veteau et al. 1995], revealed a signal with a T 1 of ~15 ms in C-less. This time constant is of the same order of magnitude as that determined with the SSM method suggesting that Trp fluorescence and electrical signal are related processes. Conformation for this assumption came from the fact that the activation energies Ea for both processes are similar (around 45 KJ/mol). Second, by using the fluorescent sugar analog Dns2-S-Gal, which monitors events close to the sugar binding site [Maehrel et al. 1998], a signal with a T 1 of ~18 ms was recorded upon Na+ addition. Finally, the fluorescent dye MIANS was used to selectively label the single Cys mutant E365C of loop 10-11. Stopped-flow measurements revealed a melibiose-induced fluorescent signal with a T 1 of 45 ms. Since electrical measurements with the MIANS-labeled E365C excluded the possibility that the label is responsible for the slower kinetics, the conformational change detected by the MIANS fluorescence was assigned to a slow transition in the cycle of MelB after melibiose binding. Ea was determined to be 96 KJ/mol corroborating, thus, the hypothesis of a different process. In conclusion, it was possible to correlate the electrical and fluorescence signals to partial reactions of the transport cycle and to determine their rate constants. According to this new model, the melibiose-induced signal detected with the Trp and electrical measurements corresponds to a step preceding the carriers’ reorientation (3 <-> 3*, k ~ 65s-1), and the melibiose-induced signal detected with the MIANS fluorescence to the reorientation itself (3* <-> 4, k ~ 20s-1).