Refine
Document Type
- Article (2)
Language
- English (2)
Has Fulltext
- yes (2)
Is part of the Bibliography
- no (2) (remove)
Institute
- Physik (2) (remove)
The 23Al(p, γ)24Si stellar reaction rate has a significant impact on the light-curve emitted in X-ray bursts. Theoretical calculations show that the reaction rate is mainly determined by the properties of direct capture as well as low-lying 2+ states and a possible 4+ state in 24Si. Currently, there is little experimental information on the properties of these states.
In this proceeding we will present a new experimental study to investigate this reaction, using the surrogate reaction 23Al(d,n) at 47 AMeV at the National Superconducting Cyclotron Laboratory (NSCL). We will discuss our new experimental setup which allows us to use full kinematics employing the Gamma-Ray Energy Tracking In-beam Nuclear Array (GRETINA) to detect the γ-rays following the de-excitation of excited states of the reaction products and the Low Energy Neutron Detector Array (LENDA) to detect the recoiling neutrons. The S800 was used for identification of the 24Si recoils. As a proof of principle to show the feasibility of this concept the Q-value spectrum of 22Mg(d,n)23Al is reconstructed.
We measured the Coulomb dissociation of 16O into 4He and 12C at the R3B setup in a first campaign within FAIR Phase 0 at GSI Helmholtzzentrum für Schwerionenforschung, Darmstadt. The goal was to improve the accuracy of the experimental data for the 12C(α,γ)16O fusion reaction and to reach lower center-ofmass energies than measured so far.
The experiment required beam intensities of 109 16O ions per second at an energy of 500 MeV/nucleon. The rare case of Coulomb breakup into 12C and 4He posed another challenge: The magnetic rigidities of the particles are so close because of the same mass-to-charge-number ratio A/Z = 2 for 16O, 12C and 4He. Hence, radical changes of the R3B setup were necessary. All detectors had slits to allow the passage of the unreacted 16O ions, while 4He and 12C would hit the detectors' active areas depending on the scattering angle and their relative energies. We developed and built detectors based on organic scintillators to track and identify the reaction products with sufficient precision.