Refine
Year of publication
- 2008 (2) (remove)
Document Type
- Article (2)
Language
- English (2)
Has Fulltext
- yes (2) (remove)
Is part of the Bibliography
- no (2)
Institute
Volatile organic compounds (VOCs) were analyzed in air and snow samples at the Jungfraujoch high alpine research station in Switzerland as part of CLACE 5 (CLoud and Aerosol Characterization Experiment) during February/March 2006. The fluxes of individual compounds in ambient air were calculated from gas phase concentrations and wind speed. The highest flux values were observed for the aromatic hydrocarbons benzene (14.3 µg m−2s−1), 1,3,5-trimethylbenzene (5.27 µg m−2s−1), toluene (4.40 µg m−2s−1), and the aliphatic hydrocarbons i-butane (7.87 µg m−2s−1), i-pentane (3.61 µg m−2s−1) and n-butane (3.23 µg m−2s−1). The fluxes were used to calculate the efficiency of removal of VOCs by snow, and the effect of temperature on removal efficiency. The removal efficiency was calculated at – 24◦C (−13.7◦C) and ranged from 37% (35%) for o-xylene to 93% (63%) for i-pentane. The distribution coefficients of VOCs between the air and snow phases were derived from published poly-parameter linear free energy relationship (pp-LFER) data, and compared with distribution coef- ficients obtained from the simultaneous measurements of VOC concentrations in air and snow at Jungfraujoch. The coefficients calculated from pp-LFER exceeded those values measured in the present study, which indicates more efficient snow scavenging of the VOCs investigated than suggested by theoretical predictions.
Both, gas and particle scavenging contribute to the transport of organic compounds by ice crystals in the troposphere. To simulate these processes an experimental setup was developed to form airborne ice crystals under atmospheric conditions. Experiments were performed in a wall independent reactor (WIR) installed in a walk-in cold chamber maintained constantly at -20°C. Aerosol particles were added to the carrier gas of ambient air by an aerosol generator to allow heterogeneous ice formation. Temperature variations and hydrodynamic conditions of the WIR were investigated to determine the conditions for ice crystal formation and crystal growth by vapour deposition. In detail, the dependence of temperature variations from flow rate and temperature of the physical wall as well as temperature variations with an increasing reactor depth were studied. The conditions to provide a stable aerosol concentration in the carrier gas flow were also studied. The temperature distribution inside the reactor was strongly dependent on flow rate and physical wall temperature. At an inlet temperature of -20°C, a flow rate of 30 L•min exp -1 and a physical wall temperature of +5°C turned out to provide ideal conditions for ice formation. At these conditions a sharp and stable laminar down draft "jet stream" of cold air in the centre of the reactor was produced. Temperatures measured at the chamber outlet were kept well below the freezing point in the whole reactor depth of 1.0 m. Thus, melting did not affect ice formation and crystal growth. The maximum residence time for airborne ice crystals was calculated to at 40 s. Ice crystal growth rates increased also with increasing reactor depth. The maximum ice crystal growth rate was calculated at 2.82 mg• exp -1. Further, the removal efficiency of the cleaning device for aerosol particles was 99.8% after 10 min. A reliable particle supply was attained after a preliminary lead time of 15 min. Thus, the minimum lead time was determined at 25 min. Several test runs revealed that the WIR is suitable to perform experiments with airborne ice crystals.