Refine
Year of publication
Document Type
- Article (18)
- Conference Proceeding (12)
- Report (2)
- Working Paper (1)
Has Fulltext
- yes (33)
Is part of the Bibliography
- no (33) (remove)
Keywords
- Q-factor (1)
- electromagnetic field (1)
- measurement (1)
Institute
- Physik (33)
Determination of field strength and quality factor of heavily HOM damped accelerator cavities
(1992)
Two methods of of measuring field strength in accelerator cavities, heavily damped with respect to higher order modes (HOM), are presented. From the results of the field measurements the coupling (damping) factor and thus the quality factor of the damped resonator can be derived. Measurements of a pillbox resonator with heavily damped TM110-mode (Q < 20) demonstrate the usefulness of the techniques presented, even in this extreme range.
Accelerating cavities exchange HOM power through interconnecting beam pipes in case of signal frequencies above the cut-off of their propagating waveguide modes. This may lead either to improved HOM damping or - in the case most severe - to unwanted phase coherence of fields to the beam. Therefore the knowledge of the scattering properties of a cavity as a line element is needed to analyse all kinds of RF cavity-cavity interaction. Since there is a lack of measurement tools capable to provide a multidimensional scattering matrix at a given frequency point, we have been developing a method for this purpose. It uses a set of 2-port S-parameters of the device under test, embedded in a number of geometrically different RF environments. The application of the method is demonstrated with copper models of TESLA cavities.
To preserve the required beam quality in an e+/e- collider it is necessary to have a very precise beam position control at each accelerating cavity. An elegant method to avoid additional length and beam disturbance is the usage of signals from existing HOM-dampers. The magnitude of the displacement is derived from the amplitude of a dipole mode whereas the sign follows from the phase comparison of a dipole and a monopole HOM. To check the performance of the system, a measurement setup has been built with an antenna which can be moved with micrometer resolution to simulate the beam. Furthermore we have developed a signal processing to determine the absolute beam displacement. Measurements on the HOM-damper cell can be done in the frequency domain using a network analyser. Final measurements with the nonlinear time dependent signal processing circuit has to be done with very short electric pulses simulating electron bunches. Thus, we have designed a sub nanosecond pulse generator using a clipping line and the step recovery effect of a diode. The measurement can be done with a resolution of about 10 micrometers. Measurements and numerical calculations concerning the monitor design and the pulse generator are presented.