550 Geowissenschaften
Refine
Year of publication
Document Type
- Article (902)
- Doctoral Thesis (194)
- Contribution to a Periodical (32)
- Book (26)
- Working Paper (22)
- Part of Periodical (21)
- Conference Proceeding (18)
- Part of a Book (9)
- Diploma Thesis (8)
- diplomthesis (7)
Language
Keywords
- climate change (11)
- Klima (8)
- Climate change (7)
- Klimaänderung (7)
- Modellierung (7)
- COSMO-CLM (6)
- Klimawandel (6)
- Palaeoclimate (6)
- precipitation (6)
- Atmospheric chemistry (5)
Institute
- Geowissenschaften (778)
- Geowissenschaften / Geographie (144)
- Biodiversität und Klima Forschungszentrum (BiK-F) (62)
- Geographie (61)
- Senckenbergische Naturforschende Gesellschaft (56)
- Präsidium (44)
- Extern (28)
- Biowissenschaften (22)
- Institut für Ökologie, Evolution und Diversität (10)
- Physik (8)
In this thesis, laboratory investigations have been conducted to investigate several processes occurring during the melt segregation (crystal settling and compaction processes), as well as during emplacement of plutons. With the help of three different sets of centrifuge experiments rates of these three magmatic processes have been evaluated. In the first series of the centrifuge experiments, the diapiric ascent of buoyant material from two source layers at different depths was studied. Through five models, the hypothesis of ascending diapirs was tested and it was demonstrated whether a rising diapir ascends straight upward or if its ascent might be deviated by another buoyant, softer – and consequently easier to travel through – layer which is located within the overburden strata. We were interested under which conditions they can be formed. For this purpose we placed perturbations on top of both the buoyant layers; either with a set-off of both the protrusions (for three of these experiments), or with both protrusion sitting directly on top of each other (for one of the experiments). In the first experiment, we omitted the perturbations, to test which pathways diapirs take which grow from natural Rayleigh-Taylor instabilities. Three others experiments differed in the viscosity contrast between the overburden and the buoyant material. Through the experimental runs, the effects of different overburden viscosities and perturbation positions on the number of the diapirs were observed. The modeling results show that two diapirs rising from the offset perturbations do not take the same pathway through the overburden layer. Rather, each diapir takes a different pathway, with the deeper diapir piercing through its overburden while rising, regardless if it was a buoyant layer or denser overburden layers. However, when the two perturbations were situated directly above each other in the different PDMS layers, this resulted in the formation of one big diapir rather than several smaller ones, and the overburden layer was less deformed than with offset perturbations. Diapiric structures as those derived from the models without perturbation and where the perturbation are offset occur within Great Kavir Basin (Iran), where numerous salt diapirs grew from several salt horizons, which show a similar spatial distribution. The resulting structure observed in the model where the two perturbations situated directly above each other, is close to what is observed in composite batholiths such as the Flasergranitoid Zone within the Bergsträßer Odenwald Crystalline Complex (Germany). The second series of models were aimed to study crystal settling within a magma. For this purpose experiments with an artificial magma of 30 vol% olivine in 70 vol% basaltic melt were conducted to elucidate the formation mechanisms and time scales of gravitational cumulates. Through the experiments, two physical processes have been observed: (i) purely mechanical compaction, and (ii) chemical compaction induced by dissolution and re-precipitation of settled crystals. The results reveals that the mechanical settling of the dense olivine suspension occurs at about 1/6 the speed of simple Stokes settling, and a sedimentation exponent n of 4.1 is found. Evidences of chemical compaction induced by dissolution and re-precipitation of settled crystals have been highlighted by a detailed analysis of the fine structure of olivine grain boundaries. This last has revealed (1) the presence of Ca, which is characteristic only for MORB-melt, at the interface of two adjacent Ol-grains even when no melt is present; (2) a not fully crystallized boundary layer between two adjacent olivine grains. The crystal size distribution curves and the grain size growth exponent n ~3.6 indicate that diffusion controlled Ostwald ripening is the dominant crystal growth mechanism in concentrated magmatic suspensions. Finally, the formation times in natural olivine adcumulates have been calculated. The last series of centrifuge experiments deals with the crystal-melt settling-floating mechanism in a system composed of natural two pyroxene gabbro. The results have revealed a vertical evolution of the major and trace elements in the melt phase. Then, a numerical modelling of the sedimentation process of the crystals has been made in order to describe the compaction evolution with time. In comparing the numerical simulation with the centrifuge modelling, the stratification of the compacted layer in the runs is reproduced in numerical models. Moreover, on the base of the numerical and centrifuge modelling, a sedimentation exponent describing a deviation of settling in concentrated suspensions from Stokes sedimentation has been evaluated. Finally, the numerical simulation is applied to the Muskox intrusion to estimate the formation time and the melt fraction evolution in using the hindered sedimentation model calculations.
IFLS-Journal. Nr. 4, 2003
(2003)
IFLS-Journal. Nr. 3, 2003
(2003)
IFLS-Journal. Nr. 2, 2002
(2002)
IFLS-Journal. Nr. 1, 2002
(2002)
In this study, I investigate the crustal and upper mantle velocity structure beneath the Rwenzori Mountains in western Uganda. This mountain range is situated within the western branch of the East African Rift and reaches altitudes of more than 5000 m. I use four different approaches that belong to the travel-time tomography method. The first approach is based on the isotropic tomographic inversion of local data, which contain information about 2053 earthquakes recorded by a network of up to 35 stations covering an area of 140×90 km2. The LOTOS-09 algorithm described here is used to realize this approach. The second approach is based on the anisotropic tomographic inversion of the same local dataset. This method employs the tomographic code ANITA, developed with my participation, which provides 3D anisotropic P and isotropic S velocity distributions based on P and S travel-times from local seismicity. For the P anisotropic model, four parameters for each parameterization cell are determined. This represents an orthorhombic anisotropy with one vertically-oriented predefined direction. Three of the parameters describe slowness variations along three horizontal orientations with azimuths of 0°, 60° and 120°, and one is a perturbation along the vertical axis. The third approach is based on tomographic inversion of the teleseismic data, which contain information about the traveltimes of P-waves coming from 284 teleseismic events recorded by the seismic network stations. The TELELOTOS code, which is my own modification of the LOTOS-09 algorithm, is used in this approach. The TELELOTOS code is designed to iteratively invert the local and/or teleseismic datasets. Finally, I present the results of the new tomographic approach, which is based on the simultaneous inversion of the joint local and teleseismic data. The simultaneous use of these datasets for the tomographic inversion has several advantages. In this case, the velocity structure in the study area can be resolved as deep as in the teleseismic approach. At the same time, in the upper part of the study volume, the resolution of the obtained models is as good as in the local tomography. The TELELOTOS algorithm is used to perform the joint tomographic inversion. Special attention is paid in this work to synthetic testing. A number of different synthetic and real data tests are performed to estimate the resolution ability and robustness of the obtained models. In particular, synthetic tests have shown that the results of the anisotropic tomographic inversion of the local data have to be considered as unsatisfactory. For all approaches used in this study, I present synthetic models that reproduce the same pattern of anomalies as that obtained by inverting the real data. These models are used to interpret the results and estimate the real amplitudes of the obtained anomalies. The obtained models exhibit a relatively strong negative P anomaly (up to -10%) beneath the Rwenzori Mountains. Low velocities are found in the northeastern part of the array at shallower depths and are most likely related to sedimentary deposits, while higher velocities are found beneath the eastern rift shoulder and are thought to be related to old cratonic crust. The presence of low velocities in the northwestern part of the array may be caused by a magmatic intrusion beneath the Buranga hot springs. Relatively low velocities were observed within the lower crust and upper mantle in the western and southern parts of the study area (beneath the rift valley and the entire length of the Rwenzori range). The higher amplitude of the low-velocity anomaly in the south can be related to the thinner lithosphere in the southern part of the Albertine rift. In the center of the study area, a small negative anomaly is observed, with the intensity increasing with depth. This anomaly is presumably related to a fluids rising up from a plume branch in the deeper part of the mantle. According to the interpretation of the local earthquake distribution, the Rwenzori Mountains are located between two rift valleys with flanks marked by normal faults. The Rwenzori block is bounded by thrust faults that are probably due to compression.