Refine
Document Type
- Doctoral Thesis (2)
- Preprint (1)
Language
- English (3) (remove)
Has Fulltext
- yes (3) (remove)
Is part of the Bibliography
- no (3) (remove)
Keywords
- detector (3) (remove)
Institute
The knowledge of the material budget with a high precision is fundamental for measurements of direct photon production using the photon conversion method due to its direct impact on the total systematic uncertainty. Moreover, it influences many aspects of the charged-particle reconstruction performance. In this article, two procedures to determine data-driven corrections to the material-budget description in ALICE simulation software are developed. One is based on the precise knowledge of the gas composition in the Time Projection Chamber. The other is based on the robustness of the ratio between the produced number of photons and charged particles, to a large extent due to the approximate isospin symmetry in the number of produced neutral and charged pions. Both methods are applied to ALICE data allowing for a reduction of the overall material budget systematic uncertainty from 4.5% down to 2.5%. Using these methods, a locally correct material budget is also achieved. The two proposed methods are generic and can be applied to any experiment in a similar fashion.
In der nuklearen Astrophysik sind Experimente mit hochgeladenen Radionukliden von großer Bedeutung. Diese exotischen Nuklide können in Schwerionenbeschleunigeranlagen hergestellt und in Speicherringen gespeichert werden. Momentan existieren weltweit zwei Anlagen, die solche Experimente ermöglichen: das GSI Helmholtzzentrum für Schwerionenforschung GmbH in Darmstadt und das Institut für moderne Physik (IMP) in Lanzhou, China. Da die Ausbeute dieser Nuklide gering ist, werden zerstörungsfreie Nachweismethoden in den Speicherringen verwendet. Diese machen von den Methoden der Spektralanalyse Gebrauch. Nicht nur die geringe Ausbeute, sondern auch die kurze Lebensdauer dieser Nuklide stellen hohe Anforderungen an die Sensitivität und Geschwindigkeit dieser Detektoren.
Eine übliche Methode ist die Verwendung kapazitiver Schottky-Sonden. Eine solche Sonde ist seit 1991 an der GSI im Speicherring ESR im Einsatz. Um die Empfindlichkeit zu erhöhen, kann man Mikrowellenkavitäten als resonante Pickups verwenden. Die von den Teilchen induzierten elektromagnetischen Felder können resonante Moden im Resonator anregen. Die Geometrie des Pickups und das verwendete Material spielen eine wesentliche Rolle in der Gestaltung der Feldbilder. Die resultierenden Signale, auch Schottky Signale genannt, werden mittels einer Antenne ausgekoppelt und anschliessend an einen Spektrumanalysator angeschlossen. Für die Analyse der gespeicherten Daten können verschiedene Methoden der Spektralschätzung wie z.B. das Multi-Taper angewendet werden. Nachdem eine externe Kalibrierung durchgeführt worden ist, kann das Pickup auch als ein Stromsensor verwendet werden.
Diese Arbeit befasst sich mit der Theorie, dem Aufbau und ersten Anwendungen eines neuen resonanten Pickups, das im Jahr 2010 in den Speicherring ESR eingebaut und in mehreren Experimenten erfolgreich eingesetzt wurde. Ein ähnliches Pickup wurde im Jahr 2011 in den CSRe im IMP Lanzhou eingebaut. Einzelne Schwerionen mit 400 MeV pro Nukleon wurden erfolgreich mit dem GSI-Pickup nachgewiesen. Das Pickup wird regelmässig in Speicherringexperimenten eingesetzt. Ähnliche Experimente sind für CSRe in Lanzhou geplant.
Terahertz (THz) technology is an emerging field that considers the radiation between microwave and far-infrared regions where the electronic and photonic technologies merge. THz generation and THz sensing technologies should fill the gap between photonics and electronics which is defined as a region where THz generation power and THz sensing capabilities are at a low technology readiness level (TRL). As one of the options for THz detection technology, field-effect transistors with integrated antennae were suggested to be used as THz detectors in the 1990s by M. Dyakonov and M. Shur from where the development of field-effect transistor-based detector began. In this work, various FET technologies are presented, such as CMOS, AlGaN/GaN, and graphene-based material systems and their further sensitivity enhancement in order to reach the performance of well-developed Schottky diode-based THz sensing technology. Here presented FET-based detectors were explored in a wide frequency range from 0.1 THz up to 5 THz in narrowband and broadband configurations.
For proper implementation of THz detectors, the well-defined characterization is of high importance. Therefore, this work overviews the characterization methods, establishes various definitions of detector parameters, and summarizes the state-of-the-art THz detectors. The electrical, optical, and cryogenic characterization techniques are also presented here, as well as the best results obtained by the development of the characterization methods, namely graphene FET stabilization, low-power THz source characterization for detector calibration, and technology development for cryogenic detection.
Following the discussion about the detector characterization, a wide range of THz applications, which were tested during the last four years of Ph.D. and conducted under the ITN CELTA project from HORIZON2020 program, are presented in this work. The studies began with spectroscopy applications and imaging and later developed towards hyperspectral imaging and even passive imaging of human body THz radiation. As various options for THz applications, single-pixel detectors as well as multi-pixel arrays are also covered in this work.
The conducted research shows that FET-based detectors can be used for spectroscopy applications or be easily adapted for the relevant frequency range. State-of-the-art detectors considered in this work reach the resonant performance below 20 pW/√Hz at 0.3 THz and 0.5 THz, as well as 404 pW/√Hz cross-sectional NEP at 4.75 THz. The broadband detectors show NEP as low as 25 pW/√Hz at around 0.6 THz for the best AlGaN/GaN design and 25 pW/√Hz around 1 THz for the best CMOS design. As one of the most promising applications, metamaterial characterization was tested using the most sensitive devices. Furthermore, one of the single-pixel devices and a multi-pixel array were tested as an engineering solution for a radio astronomy system called GREAT in a stratosphere observatory named SOFIA. The exploration of the autocorrelation technique using FET-based devices shows the opportunity to employ such detectors for direct detection of THz pulses without an interferometric measurement setup.
This work also considers imaging applications, which include near-field and far-field visualization solutions. A considerable milestone for the theory of FET technology was achieved when scanning near-field microscopy led to the visualization of plasma (or carrier density) waves in a graphene FET channel. Whereas another important milestone for the THz technology was achieved when a 3D scan of a mobile phone was performed under the far-field imaging mode. Even though the imaging was done through the phone’s plastic cover, the image displayed high accuracy and good feature recognition of the smartphone, inching the FET-based detector technology ever so close to practical security applications. In parallel, the multi-pixel array testing was carried out on 6x7 pixel arrays that have been implemented in configurable-size aperture and imaging configurations. The configurable aperture size allowed the easier detector focusing procedure and a better fit for the beam size of the incident radiation. The imaging has been tested on various THz sources and compared to the TeraSense 16x16 pixel array. The experimental results show the big advantage of the developed multi-pixel array against the used commercial technology.
Furthermore, two ultra-low-power applications have been successfully tested. The application on hyper-frequency THz imaging tested in the specially developed dual frequency comb and our detector system for 300 GHz radiation with 9 spectral lines led to outstanding imaging results on various materials. The passive imaging of human body radiation was conducted using the most sensitive broadband CMOS detector with a log-spiral antenna working in the 0.1 – 1.5 THz range and reaching the optical NEP of 42 pW/√Hz. The NETD of this device reaches 2.1 K and overcomes the performance limit of passive room-temperature imaging of the human body radiation, which was less than 10 K above the room temperature. This experiment opened a completely new field that was explored before only by the multiplier chain-based or thermal detectors.
...